Chromaline CP Tex Emulsion - Waterbase, Discharge, Plastisol Inks
Chromaline CP Tex Emulsion - Waterbase, Discharge, Plastisol Inks

Chromaline CP Tex Emulsion - Waterbase, Discharge, Plastisol Inks

CH CPTEX

CP Tex takes diazo emulsions to another level.  With an enormous window of exposure latitude, CP Tex provides textile shops a single emulsion solution when printing with both plastisol and water-based inks.

Product options:

32.03 $32.03

Features:

  • Color: Light Violet
  • Solids: 44%
  • Viscosity: Medium
  • High resolution
  • Durable, yet reclaimable
  • Hardener not necessary for WB inks

Degrease - Using a mesh degreaser, work up a lather on both sides of mesh. Flood screen and frame thoroughly with water, then dry.

Coat - Slowly apply first coat to print side. Then coat squeegee side with one coat. If a thicker stencil is desired, additional coats may be applied to the squeegee side while the emulsion is wet. Note that one coat on each side with ChromaBlue is similar to four coats wet on wet with typical diazo based emulsions. Dry thoroughly between coats.

Dry - Thoroughly dry screen in horizontal position, print side down, using a totally dark, clean drying cabinet. Temperature should not exceed 110 degrees

Expose - Place emulsion side of photopositive in contact with print side of screen. Exposure times for can vary based on your light source and coating methods; accurate exposure is important for optimal results. An exposure calculator is highly recommended to dial in your exposure times.

Develop - Gently spray both sides of screen with lukewarm water, wait 30 seconds then gently wash print side of the screen until image is fully open. Rinse both sides thoroughly. Dry screen completely and you are ready to print

*Handle in light safe conditions and make sure to store in a cool dry place.

Full Description

Features:

  • Color: Light Violet
  • Solids: 44%
  • Viscosity: Medium
  • High resolution
  • Durable, yet reclaimable
  • Hardener not necessary for WB inks

Technical Specifications

Degrease - Using a mesh degreaser, work up a lather on both sides of mesh. Flood screen and frame thoroughly with water, then dry.

Coat - Slowly apply first coat to print side. Then coat squeegee side with one coat. If a thicker stencil is desired, additional coats may be applied to the squeegee side while the emulsion is wet. Note that one coat on each side with ChromaBlue is similar to four coats wet on wet with typical diazo based emulsions. Dry thoroughly between coats.

Dry - Thoroughly dry screen in horizontal position, print side down, using a totally dark, clean drying cabinet. Temperature should not exceed 110 degrees

Expose - Place emulsion side of photopositive in contact with print side of screen. Exposure times for can vary based on your light source and coating methods; accurate exposure is important for optimal results. An exposure calculator is highly recommended to dial in your exposure times.

Develop - Gently spray both sides of screen with lukewarm water, wait 30 seconds then gently wash print side of the screen until image is fully open. Rinse both sides thoroughly. Dry screen completely and you are ready to print

*Handle in light safe conditions and make sure to store in a cool dry place.

MSDS

Chromaline CP Tex Safety Data Sheet

Chromaline CP Tex Technical Data Sheet