Siser Easyweed 20” Stretch Black Heat Transfer Vinyl

Siser

Activewear has met its match! EasyWeed Stretch by Siser delivers all the benefits of our EasyWeed heat transfer vinyl and combines it with super stretchability to create one remarkable HTV! The thinnest of any Siser material, EasyWeed Stretch has a true matte finish that’s available in over 20 popular colors! While EasyWeed Stretch is ideal for performance apparel from spandex to dri-fit, the soft hand and light weight often make it a favorite for other garments such as: tank tops, onesies, and almost anything else. Check out the Top Ten Siser Heat Transfer Vinyl Tips for other great uses for HTV! EasyWeed Stretch can even be cut with laser systems.

EasyWeed Stretch is 85 Microns / 3.35 Mils and is a PU composition.

$12.00

QuantityBulk Purchase Pricing
1 - 4$12.00 Per Item
5 - 9$10.00 Per Item
10 - 24$9.00 Per Item
25 - 49$8.50 Per Item
50 or more$8.00 Per Item
SKU: Siser EasyWeed Stretch Black 20 Categories: ,

Adheres To:

  • 100% Cotton
  • Poly / Cotton Blends
  • 100% Uncoated Polyester
  • Lycra / Spandex

Composition: Polyurethane
Blade: 45° or 60°
Thickness: 85 Microns/3.5 Mils
Layerable: Yes
Actual Width: 19.66″
Backing: Pressure Sensitive
Finish: True Matte Finish

Application instructions (home iron)

• Set iron dial between Cotton and Linen
• Cover design with Multipurpose paper or Heat Transfer Cover Sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with firm pressure (do not slide iron)
• Press each section of design for 20 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 5-10 seconds
• Peel carrier hot or cold
Application Instructions (heat press)

• Cover design with Multipurpose paper or Heat Transfer Cover Sheet
• Preheat garment for 2-3 seconds
• Apply design at 320°F/160°C
• Use firm pressure for 20 seconds
• Peel carrier hot or cold

 

Cricut:   Blade: Standard   Setting: Iron-on

Silhouette Cameo:   Blade: Standard, 4   Material: Heat Transfer, Smooth   Speed: 8   Force: 4

Brother ScanNCut:   Blade: Standard, 2   Cut Speed: 1   Cut Pressure: 1

Roland GX/GS-24:   Blade: 45°   Gram Force: 60-70   Offset: .250   Speed: 30 cm/s

Graphtec:   Blade: 45°   Force: 9-10   Tool: CB09U+0   Speed: 30 cm/s

MH, SC2, LP3, and Titan1:   Blade: 45°/60°   Gram Force: 80-85   Speed: 300 mm/s    *Blade Advancing Varies

Titan 2 & 3:    Blade: 45°/60°   Gram Force: 80-85   Speed: 300 mm/s   *Blade Advancing Varies


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Laundering:

  • Wait 24 hours before 1st wash
  • Machine wash cold / mild detergent
  • Dry on normal dryer setting
  • Do not dry clean

Product categories

You May Also Like

Additional Options