Printers Choice Dual Cure Pink Screen Printing Emulsion – Versatile Dual Cure Emulsion for Water-Based, Discharge & Plastisol Inks

Screen Printing Step-by-Step Guide:

Degrease:

• Using a mesh degreaser, create a lather on both sides of the mesh.
• Flood the screen and frame thoroughly with water, then allow it to dry.

Coat:

• Begin by slowly applying the first coat to the print side of the screen.
• Follow this by applying one coat to the squeegee side.
• If a thicker stencil is desired, additional coats can be applied to the squeegee side while the emulsion is still wet.
• Note that one coat on each side with ChromaBlue is equivalent to approximately four coats applied wet on wet with typical diazo-based emulsions.
• Ensure thorough drying between coats.

Dry:

• Place the screen in a horizontal position with the print side facing down.
• Use a completely dark and clean drying cabinet.
• Maintain a temperature not exceeding 110 degrees Fahrenheit for thorough drying.

Expose:

• Place the emulsion side of the photopositive in contact with the print side of the screen.
• Exposure times may vary depending on your light source and coating methods, so precise exposure is crucial for optimal results.
• It is highly recommended to use an exposure calculator to determine accurate exposure times.

Develop:

• Gently spray lukewarm water on both sides of the screen.
• Wait for 30 seconds, then gently wash the print side of the screen until the image is fully open.
• Rinse both sides of the screen thoroughly.
• Allow the screen to dry completely, and it will be ready for printing.

Additional Notes:

• Always handle the materials in light-safe conditions.
• Store them in a cool, dry place to maintain their quality.

These steps will help ensure a successful screen printing process with ChromaBlue emulsion.