Siser Easyweed 20” EasyReflective Silver Heat Transfer Vinyl – Out of Stock

Siser

EasyReflective is Siser’s only reflective HTV with a pressure sensitive (sticky) carrier just like EasyWeed®! This highly reflective heat transfer vinyl is truly an exceptional polyurethane product due to its glass bead construction that illuminates the darkest of conditions. The pressure sensitive carrier allows you to re-stick lifting material or replace a piece that’s accidentally weeded away. With a low application temperature and simple warm peel, EasyReflective can be applied to all kinds of garments and accessories that need to stand out in low lighting. Heat apply EasyReflective with a heat press or home iron for increased visibility on sports garments, pet clothes, construction crew uniforms, and more!

EasyReflective is 140 Microns / 5.5 Mils and is a PU composition.

$13.00

Out of stock

Due to a manufacturing defect the current Easy Reflective is unavailable. We will update as soon as we have more in stock.

Adheres To:

  • 100% Cotton
  • Poly / Cotton Blends
  • 100% Uncoated Polyester

Composition: PET
Blade: 45° or 60°
Thickness: 140 Microns/5.5 Mils
Layerable: Top-most layer only
Actual Width: 19.66″
Backing: Pressure Sensitive
Finish: Reflective Finish

Application instructions (home iron)

• Set iron dial between Cotton and Linen
• Cover design with Multipurpose Paper or Heat Transfer Cover Sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 10 seconds
• Peel carrier warm
Application Instructions (heat press)

• Cover design with Multipurpose Paper or Heat Transfer Cover Sheet
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 15 seconds
• Peel carrier warm (at least 15 seconds off press)

 

Cricut:   Blade: Standard   Setting: Iron-on

Silhouette Cameo:   Blade: Standard, 3   Material: Heat Transfer, Smooth   Speed: 8   Force: 6

Brother ScanNCut:   Blade: Standard, 2   Cut Speed: 1   Cut Pressure: 1
Roland GX/GS-24:   Blade: 45°   Gram Force: 80-90   Offset: .250   Speed: 25-50 cm/s

Graphtec:   Blade: 45°   Force: 9-10   Tool: CB09U+0   Speed: 30 cm/s

MH, SC2, LP3, and Titan1:   Blade: 45°/60°   Gram Force: 80-85   Speed: 300 mm/s    *Blade Advancing Varies

Titan 2 & 3:   Blade: 45°/60°   Gram Force: 60-65   Speed: 300 mm/s   *Blade Advancing Varies


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Laundering:

  • Wait 24 hours before 1st wash
  • Machine wash warm or cold / mild detergent
  • Dry on normal dryer setting
  • Do not dry clean

 

Product categories

You May Also Like

Additional Options