Siser 15” StripFlock Pro Black Heat Transfer Vinyl

Siser

A great alternative to embroidery, StripFlock Pro heat transfer vinyl gives logos a raised, textured, suede-like feel. The fuzzy opaque colors make StripFlock Pro excellent for retro designs like you’d find in a mall in the 80’s, or anytime you want a deep, rich look. StripFlock Pro is thick enough to cover hat seams, yet also looks excellent on bags, denim, and other garments that need textured visual interest. Use Stripflock Pro as a base layer and cover with other materials such as EasyWeed Stretch for an embossed look, or layer with more StripFlock! The ability to layer this material with itself and others allows you to say “yes” to multi-color designs. However, please note that for best results all fluorescent colors are recommended to be layered with the knockout method and the carrier peeled warm.

StripFlock Pro is 410 Microns / 16.1 mils and is a PVC composition.

$12.00

Out of stock

SKU: Siser StripFlock Black 15 Categories: ,

Adheres To:

  • 100% Cotton
  • Poly / Cotton Blends
  • 100% Polyester

Composition: PET
Blade: 45° or 60°
Thickness: 100 Microns/3.9 Mils
Layerable: Must Be Top Most Layer
Actual Width: 14.75″
Backing: Pressure Sensitive
Finish: Suede-like

Application instructions (home iron)

• Set iron dial between Cotton and Linen
• Cover design with Kraft Paper or Heat Transfer Cover Sheet
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 15 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 10 seconds
• Peel carrier warm
Application Instructions (heat press)

• Cover design with Kraft Paper or Heat Transfer Cover Sheet
• Preheat garment for 2-3 seconds
• Apply design at 311°F/155°C
• Use medium pressure for 15 seconds
• Peel carrier warm (at least 10 seconds off press)

 

Cricut:   Blade: Standard   Setting: Iron-on+

Silhouette Cameo:   Blade: Standard, 4   Material: Heat Transfer, Flocked   Speed: 5   Force: 6

Brother ScanNCut:   Blade: Standard, 4   Cut Speed:   Cut Pressure: 2

Roland GX/GS-24:   Blade: 45°   Gram Force: 80-120   Offset: .250   Speed: 30 cm/s

Graphtec:   Blade: 45°   Force: 10   Tool: CB09U+0   Speed: 30 cm/s

MH, SC2, LP3, and Titan1:   Blade: 45°/60°   Gram Force: 100-110   Speed: 180 mm/s    *Blade Advancing Varies

Titan 2 & 3:    Blade: 45°/60°    Gram Force: 100-110   Speed: 300 mm/s   *Blade Advancing Varies


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Laundering:

  • Wait 24 hours before first wash
  • Machine wash warm or cold / mild detergent
  • Dry on normal dryer setting
  • Do not dry clean

 

 

Product categories

You May Also Like

Additional Options