Note: You Must Use the AG-CLA-100 at an addition rate of 1.5% by weight added to the Ink when printing on Polyesters, Nylon Lycra and Performance Fabrics. This enables you to reduce curing temperatures to 280ºF (138ºC). Wash Tests Must Not Be Done Until 48 Hours After Curing. All Allureglow Inks are Ready to Use Inks, just mix them up and their ready to use. Mixing should be done with a high speed drill or drill press using a Type 2 Dispersion Blade. Continue to Mix Ink occasionally throughout production run. Keep lids on containers to avoid contamination and drying of the Ink. Mist screens as needed with water, if Ink is being used in extremely hot environments to prevent screens from drying out or clogging. Do Not Mix With Any Other Inks or Color Concentrates Do Not Underprint Regardless of the Color of the Garment For Best Results: Use Medium to Heavy Flood and Moderate Squeegee Pressure on both Automatic and Manual Presses Allureglow USA Reflective Ink can be printed using a single or double pass through 86 to 180 Mesh Screens depending on the color and amount of reflectivity you are trying to achieve. Cure Ink at 340°F (170°C) Unless AG-CLA-100 is used than it should be 280°F (. Always Test Dryer Temperatures prior to and during production. Curing Time will be between 120 & 180 seconds, depending on amount of ink deposit and color of garment. Always perform wash test prior to production, to ensure proper adhesion to the fabric, prior to production runs. If AG-CLA-100 is used wait 48 hours after curing before washing. Clean-Up can be done using Soap and Water Testing and viewing can be best done in a dark room or hallway, place print at least 10 feet away from you on a wall, place a good flashlight between you eyes and point at the print, the light should reflect back at the viewer. For best long term durability wash in cold water on the delicate cycle and wash inside out. Do Not Use Bleach. Do Not Iron on Print. Line or Hang Dry Any application not referenced in this Technical Data should be pre-tested prior to any production run is done. Manufactured By: Allureglow USA and Allureglow USA makes no representation as to the suitability of any given products; it is up to the buyer or user to determine if the product is suitable for the given application. (888) 493-4569 or info@allureglowusa.com Directions and Helpful Information for Printing with the PS Series Reflective Inks For Best Results, Always High Speed Mix Inks throughly with the proper diameter Type 2 Dispersion Blade and either a High Speed Drill or Drill Press, prior to using. Keep lids on containers to avoid contamination. Do Not Mix With Any Other Inks Do Not Underprint Any Color Garment Prior to Using These Inks PS-2045-RR MUST be printed using a Single Pass Print with 110 Monofilament Mesh Screens. A Double Pass may be done to improve the Daytime Color, however some reflectivity will be lost. Cure Ink at 340°F (170°C) for 90 to 120 Seconds depending on the thickness of the ink deposit. Always Test Dryer Temperatures prior to and during production. Always perform wash test prior to production, to ensure proper adhesion to the fabric. Clean-Up can be done using any Eco-Friendly Screen Wash Suitable for Plastisol Inks For best long term durability wash in cold water on the delicate cycle and wash inside out. Do Not Use Bleach. Do Not Iron on Print. Line or Hang Dry Any application not referenced in this Technical Data should be pre-tested prior to any production run is begun.
