Excalibur X150 Nylon Bonding Agent – 16 Ounce

TECHNICAL INFORMATION:
Mixing: Add 10% by weight of X150 to any 500PF Series ink and mix thoroughly.
Gel Temperature: Ink will gel on surface at 240° F (116° C).
Curing: Ink film will fully cure when the entire ink film reaches 320° F (160° C.) and held at this temperature for at least 15 seconds.
Mesh: Mesh sizes between 110-200/inch (43T-80Tcm) produce excellent results.
Stencil: Any emulsion that produces a stencil compatible with plastisol inks is recommended.
Modification: None recommended.
Squeegee: 70 durometer or 90/70/90 triple durometer blades are recommended.
Printing Technique: A print/flash/print technique may be necessary to produce desired results on dark backgrounds.
Clean-up: Ink Degradents, Spray Wipes, etc…

TESTING FOR ADHESION:
Because no post hardening occurs after curing, the print may be tested for adhesion immediately after cooling.

CAUTION:
Always test finished prints for curing, adhesion, bleed-resistance, opacity and desired look prior to beginning full production runs. Lancer Group International cannot guarantee the results or back claims that this mixed ink will test phthalate-free if this product is used with any other plastisol ink other than plastisol inks manufactured by Lancer Group International.  Test results by a third-party laboratory verifying that Excalibur plastisol inks are phthalate-free and lead-free are available upon request.

Excalibur X150 Specifications Sheet

Excalibur X150 MSDS