FDC 3700 24” 242 Burgundy Glitter Sign Vinyl – Premium Crafting Material

Cutting and Applying FDC 3700 Sign Vinyl to a Smooth Surface – Step-by-Step Guide:

Materials Needed:

• FDC 3700 Sign Vinyl
• Transfer tape
• Application squeegee or a flat-edged tool
• Smooth, clean surface for application

Instructions:

1. Prepare Your Design:

• Ensure your design is ready for cutting. You can create or import your design into a vinyl cutting software compatible with your cutting machine.

2. Load the Vinyl:

• Load the FDC 3700 Sign Vinyl onto your vinyl cutter, ensuring it is secured and aligned properly for precise cutting.

3. Adjust Cutting Settings:

• Configure your vinyl cutter settings according to the thickness of the FDC 3700 Sign Vinyl and the intricacy of your design. Consult your vinyl cutter’s manual for specific settings.

4. Cut Your Design:

• Start the cutting process and let your machine accurately cut out your design. Once finished, carefully unload the vinyl.

5. Weed the Excess Vinyl:

• Carefully remove the excess vinyl surrounding your design using a weeding tool. This will leave only your intended design on the vinyl backing.

6. Apply Transfer Tape:

• Cut a piece of transfer tape slightly larger than your design.
• Peel the backing off the transfer tape and place it adhesive-side down on top of your weeded vinyl design.
• Use a squeegee or flat-edged tool to press the transfer tape firmly onto the vinyl, ensuring there are no air bubbles.

7. Prepare the Surface:

• Ensure the smooth surface where you’ll be applying the vinyl is clean, dry, and free of any dust or debris. Use a cleaning solution if necessary.

8. Position the Vinyl:

• Carefully position the design with the transfer tape onto the target surface. Use reference points or guidelines to align it accurately.

9. Apply the Vinyl:

• Starting from one edge, use the squeegee or flat-edged tool to press the vinyl and transfer tape onto the surface. Apply even pressure to ensure proper adhesion.

10. Remove Transfer Tape:

• Slowly and at a sharp angle, peel back the transfer tape from the vinyl. Ensure the vinyl adheres to the surface, and if any part lifts, press it down and continue peeling.

11. Smooth Out Air Bubbles:

• Inspect the applied vinyl for any remaining air bubbles. If present, use the squeegee to smooth them out gently, pushing them towards the nearest edge.

12. Final Check:

• Carefully inspect the applied vinyl for any imperfections or areas that may need additional attention. Make any necessary adjustments.

You’ve successfully cut and applied FDC 3700 Sign Vinyl to a smooth surface. Your finished product should now showcase your design with precision and durability.

Technical Specifications:

• Film Technology: Cast
• Film Thickness: 3.0 mil
• Color Availability: 17 colors (Refer to the color chart)
• Blockout: Not Applicable
• Finish: Gloss
• Outdoor Durability: 5 years (When properly processed and displayed, expected durability for unprinted media, vertical exposure, and ideal conditions)
• Adhesive: Permanent (Clear)
• Liner: 78# Kraft
• Conformability: Suitable for flat surfaces and simple curves
• Application: Designed for flat surfaces and simple curves
• Printing: Screen (A print test is recommended before production to assess suitability based on printer, rip, ink type, and ink set. Allow a minimum of 24 hours for inks to dry and outgas before lamination, cutting, or application)
• Temperature: Minimum application temperature is 40°F (Applicable to graphics, substrate, and environment). Service temperature range: -40°F to 200°F
• Shelf Life: 1 year (When stored at 70°F and 50% relative humidity)

FDC 3700 Premium Ultra Metallic Sign Vinyl Data Sheet