Chromaline AccuJet Inkjet Waterproof Film 24″x100’ Roll
Chromaline AccuJet is a water-resistant inkjet film accommodates any dye-based inkjet system. AccuJet is perfect for printing positives, negatives, 4-color separations or display graphics. AccuJet provides exceptional quality and consistent results.
- Made in the USA
- Compatible with Pigment and Dye-Based Inks
- High Quality Positive
- Excellent Density & Clarity — DMAX up to 4.0, DMIN .12
- Fast drying
Bottom Line: AccuJet is our economy line of inkjet films, backed by Chromaline’s experienced technical support crew.
Be sure to optimize your output by pairing AccuJet with our AccuInk!
- Size: 24″x100′ Roll
- Quantity: 1 Roll
- Core Width: 2″
1. Prepare artwork for output.
Remember, the quality of your digital artwork will determine the quality of your positive/negative. Artwork should have smooth lines and edges and be of adequate resolution.
PLEASE NOTE: A minimum of 1440 dpi is recommended.
2. Load the film into the printer.
It is important to load the printer so that the coated side of the film will be face-up under the print head. Most printers require the film to be loaded coated side down in the printer tray. As the film is fed through the printer, the coated side will face upward to receive the ink. If your printer loads from the back or if you are using rolls, the film should be loaded with the coated side facing up.To assist in determining the proper print side, the coated print side of the film has a slightly duller appearance.
3. Check printer settings.
Make sure printer is set for the highest resolution and print quality. Note that the higher the resolution, the slower the print. Next, set the Media Setting to Photo Quality Glossy Film (if an option, otherwise choose similar film or transparency setting). Options will vary based on printer and software available. Then, set ink deposit for optimum results.
TIP: Experiment with the setting options available with your printer to determine the best set-up for your requirements. If positive seems light or lacks density, try increasing the print quality or amount of ink deposit.
AccuJet inkjet film dries quickly. With most inks, the positive will be dry and ready for use in less than 2 minutes. Drying times will vary based on printers, inks and conditions. Note: Always make sure positive is completely dry before using. Transfer or marring of image can occur if used before completely dry. Refer to product selection chart for ink type.
PLEASE NOTE: AccuJet inkjet films are designed to work with standard aqueous inkjet printers. Results will vary based on printer used, type of ink, software and artwork quality. Generally, printers with higher resolution capability will yield better looking positives. But remember, image quality depends the most on having quality artwork with adequate resolution and smooth line edges. As with any digital media, experimentation is necessary to determine the proper equipment settings to achieve desired results.
TIP: A third party RIP such as AccuRip® or Wasatch Softrip® is recommended for best results.
TIP: Printing Environment should be 65° – 75°F with a relative humidity of 40 – 70% for best results. Low humidity will cause curling.
Positives/negatives created with AccuJet inkjet film are re-usable and can be stored for later use. For best results, interleaf positives with a clean piece of newsprint and store in a low humidity environment.
- Water Resistant – Yes
- Density DMAX up to – 3.5
- Clarity DMIN – .07
- Halftones – Up to 65 lpi
- Color Printing Not Recommended
- Ink Type Dye, Pigment
*Pigment-based inks vary significantly depending on manufacturer.
*Thorough testing is recommended prior to production use