Siser 15” BlackBoard™ Heat Transfer Vinyl
Now you can turn any fabric into a writable surface that can be used over and over again! New BlackBoard® heat transfer vinyl by Siser®, transforms plain materials into a walking chalkboard – without making you feel like a walking sandwich board! Lightweight and super soft, BlackBoard is unlike any HTV you’ve ever experienced. This revolutionary material only needs 275°F of heat with medium pressure for just 15 seconds to create a machine washable chalkboard! With a low application temperature and warm peel carrier, this HTV is ideal for heat sensitive materials.
Compatible with standard chalk, Blackboard is as easy to re-use as it is to apply. Simply wipe clean with a damp cloth to start again! There are countless ways to advertise, organize, and customize with BlackBoard heat transfer vinyl.
$11.99
Description
Adheres To:
- 100% Cotton
- Poly / Cotton Blends
- 100% Uncoated Polyester
Blade: 45° or 60°
Composition: Polyurethane
Thickness: 90 Microns/3.5 Mils
Actual Width: 14.75″
Backing: Pressure Sensitive
Layerable: Not recommended
Finish: Semi-gloss
Technical Specifications
Application instructions (home iron) • Set iron dial between Cotton and Linen • Cover with Heat Transfer Cover Sheet or Multipurpose Paper • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 10-15 seconds • If areas of design lift after application, replace cover sheet and re-press for 10 seconds • Peel carrier warm |
Application Instructions (heat press) • Cover with Heat Transfer Cover Sheet or Multipurpose Paper • Preheat garment for 2-3 seconds • Apply design at 275°F/135°C • Use medium pressure for 15 seconds • Peel carrier warm |
![]() |
Cricut: Blade: Standard Setting: Paper |
![]() |
Silhouette Cameo: Blade: Standard, 2 Material: Heat Transfer, Smooth Speed: 5 Force: 8 |
![]() |
Brother ScanNCut: Blade: Standard, 2 Cut Speed: 1 Cut Pressure: 1 |
![]() |
Roland GX/GS-24: Blade: 45° Gram Force: 70-80 Offset: .250 Speed: 50 cm/s |
![]() |
Graphtec: Blade: 45° Force: 7-8 Tool: CB09U+0 Speed: 50 cm/s |
![]() |
MH, SC2, LP3, and Titan1: Blade: 45°/60° Gram Force: 80-85 Speed: 300 mm/s *Blade Advancing Varies |
![]() |
Titan 2 & 3: Blade: 45°/60° Gram Force: 60-65 Speed: 300 mm/s *Blade Advancing Varies |
Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.
Laundering:
- Wait 24 hours before first wash
- Machine wash cold / mild detergent
- Dry on normal dryer setting
- Do not dry clean
Technical Sheets / Safety Data Sheets / Documents
Reviews
Only logged in customers who have purchased this product may leave a review.
Reviews