Printers Choice Striker LB White Non-Phthalate, High Opacity Plastisol Ink
Printers Choice Striker LB White Non-Phthalate, High Opacity Plastisol Ink

Printers Choice Striker LB White Non-Phthalate, High Opacity Plastisol Ink

RC PC Striker LB

PRINTERS CHOICE STRIKER LB WHITE is a low bleed Plastisol with high opacity. Striker LB White Plastisol Ink is formulated for printing on 100% cotton, polyester, and 50/50 polyester/cotton blends with exceptional bleed resistance. Striker LB White Plastisol Ink can be used as an underlay or highlight or both. It has been formulated to provide excellent coverage and printability with a soft hand not commonly found among low bleed whites. With its creamy consistency, Striker LB White Plastisol Ink is designed to accommodate higher mesh counts, but is exceptional when using mesh 260 and below. Cure at 320°F for 2-3 minutes for optimum results.

Product options:

29.99 $29.99

FEATURES:

  • Optically bright white
  • Matte finish
  • Prints through fine meshes
  • Use as a first-down, underbase flash white or an overprint stand-alone white
  • Good bleed resistance
  • Odorless

Application & Storage Information:

Recommended Fabrics: Light colored 100% cotton or cotton/polyester blends. Use an underbase for printing dark fabrics.
Ink Application: Colors should be printed without any modifications. If thinning is required, use Curable Reducer (1% to 5% by volume).
Screen Mesh & Emulsion: 110 to 305
Emulsion:  Any direct or indirect lacquer resistant emulsion. Use 35 to 70 micron capillary film for best results.
Squeegee: 60-70 Durometer: Sharp Edge 60-90-60 or 70-90-70 Triple Durometer: Sharp Edge
Cure Temperature: 325 Degrees for a minute to a minute and half.  Entire ink film. Test dryer temperatures and wash test printed product before and during a production run.
Clean-up: Printers Choice Ink Degradant or any environmentally friendly plastisol screen wash.
Storage of ink containers: Recommend storage at 65F to 90F (18C to 32C). Avoid storage in direct sunlight. Keep containers well sealed.

Full Description

FEATURES:

  • Optically bright white
  • Matte finish
  • Prints through fine meshes
  • Use as a first-down, underbase flash white or an overprint stand-alone white
  • Good bleed resistance
  • Odorless

Technical Specifications

Application & Storage Information:

Recommended Fabrics: Light colored 100% cotton or cotton/polyester blends. Use an underbase for printing dark fabrics.
Ink Application: Colors should be printed without any modifications. If thinning is required, use Curable Reducer (1% to 5% by volume).
Screen Mesh & Emulsion: 110 to 305
Emulsion:  Any direct or indirect lacquer resistant emulsion. Use 35 to 70 micron capillary film for best results.
Squeegee: 60-70 Durometer: Sharp Edge 60-90-60 or 70-90-70 Triple Durometer: Sharp Edge
Cure Temperature: 325 Degrees for a minute to a minute and half.  Entire ink film. Test dryer temperatures and wash test printed product before and during a production run.
Clean-up: Printers Choice Ink Degradant or any environmentally friendly plastisol screen wash.
Storage of ink containers: Recommend storage at 65F to 90F (18C to 32C). Avoid storage in direct sunlight. Keep containers well sealed.

MSDS

Printers Choice Striker White LB Plastisol Ink Safety Data Sheet