Printers Choice Striker Black Matte Plastisol Ink

Using Striker Black Matte Plastisol Ink – Step-by-Step Guide:

1. Screen Preparation:

• Begin by ensuring your screen is clean and free from any residual ink or emulsion. A clean screen ensures the best results.

2. Ink Mixing (if needed):

• If you need to adjust the ink’s consistency or color, follow the manufacturer’s instructions to mix it thoroughly. Striker Black Matte is usually ready to use, but customization is possible if required.

3. Screen Setup:

• Secure the screen onto your printing press, ensuring proper alignment with your print substrate.

4. Printing:

• Load the screen with Striker Black Matte Plastisol Ink, either by pouring it onto the screen or using a scoop coater to flood the screen.
• Position the substrate (e.g., a t-shirt) beneath the screen, ensuring proper registration for accurate printing.

5. Squeegee Pass:

• With the ink-loaded screen in place, make a smooth and consistent squeegee pass across the screen to transfer the ink onto the substrate.
• Maintain even pressure and a consistent angle for each pass.

6. Multiple Layers (if needed):

• If creating a multi-color design, use a flash dryer to partially cure the first layer of ink before applying subsequent colors.
• Repeat the printing process for each color, curing each layer separately.

7. Curing:

• To cure Striker Black Matte ink, use a heat source such as a conveyor dryer or a heat press.
• Follow the manufacturer’s recommendations for curing temperature and time, but typically, plastisol inks are cured at temperatures around 280°F (137°C).
• Ensure the entire design reaches the required temperature for proper curing.

8. Final Inspection:

• After curing, inspect the print for quality, including color vibrancy and adhesion. The matte finish of Striker Black Matte should be evident.

9. Customer Responsibility for Testing:

• It is the customer’s responsibility to always perform a test to ensure fusion and proper curing of the ink. Variables such as equipment and environmental conditions can affect curing, so a test run is crucial to achieve the desired results.

10. Clean-Up:

• Clean your screen, squeegee, and any other tools immediately after printing using an appropriate cleaning solution or ink remover.

11. Storage:

• Seal the container of Striker Black Matte Plastisol Ink tightly to prevent drying. Store it in a cool, dry place, away from direct sunlight and extreme temperatures.

By following these directions and conducting a proper test for curing, you’ll effectively use Striker Black Matte Plastisol Ink for your screen printing projects, achieving vibrant, soft-hand prints with a matte finish that will captivate your audience.