Siser EasyWeed 20” Rainbow Twinkle Heat Transfer Vinyl
Wishing for a heat transfer vinyl like no other? Well you can thank your lucky stars because your wish was granted with Twinkle HTV! Twinkle’s silicone-like surface holds brilliant colors that appear to practically shine their own light when the glitter winks and wavers. The intense sparkle gives Twinkle a slight, but significant reflective quality. Every color of Twinkle is topped with a mesmerizing glossy glaze that feels fantastic. Whether it’s the lone focus or an incredible accent, Twinkle is your new show stopping heat transfer vinyl!
Twinkle is 225 Microns / 9 Mils and is a PU composition.
- 20″ width
- 225 microns thick
- Sticky liner
- Reflective like effect
- Glitter look with smooth feel
- Shines in the light
- CPSIA certified child safe
$12.50
-
Description
Wishing for a heat transfer vinyl like no other? Well you can thank your lucky stars because your wish was granted with Twinkle HTV! Twinkle’s silicone-like surface holds brilliant colors that appear to practically shine their own light when the glitter winks and wavers. The intense sparkle gives Twinkle a slight, but significant reflective quality. Every color of Twinkle is topped with a mesmerizing glossy glaze that feels fantastic. Whether it’s the lone focus or an incredible accent, Twinkle is your new show stopping heat transfer vinyl!
Twinkle is 225 Microns / 9 Mils and is a PU composition.
- 20″ width
- 225 microns thick
- Sticky liner
- Reflective like effect
- Glitter look with smooth feel
- Shines in the light
- CPSIA certified child safe
Technical Specifications
| Application instructions (home iron) • Set iron dial between Cotton and Linen • Cover design with Multipurpose paper or Heat Transfer Cover Sheet • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 15 seconds • If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds • Peel carrier warm |
Application Instructions (heat press) • Cut in reverse • Weed excess material • Preheat garment for 2-3 seconds • Apply design at 305°F/150°C • Use medium/firm pressure for 15 seconds • Peel carrier warm |
 |
Cricut: Blade: Standard Setting: Glitter Iron-on |
 |
Silhouette 4: Blade: Auto-Blade, 3 Speed: 8 Force: 10 |
 |
Brother ScanNCut: Blade: Auto-Blade Cut Speed: 1 Cut Pressure: 4 *Half Cut On |
 |
Roland GX/GS-24: Blade: 45° Gram Force: 130-160 Offset: .250 Speed: 30 cm/s |
 |
Graphtec: Blade: 45° Force: 13 Offset: .250 Speed: 35 cm/s |
Laundering:
• Wait 24 hours before 1st wash
• Machine wash cold / mild detergent
• Dry on low dryer setting
• Do not use bleach or dry clean
