Siser Easyweed 20” Holographic Navy Blue Heat Transfer Vinyl
Holographic contains color changing chips that create the effect of depth and dimension. Available in several special effect colors and finishes, Holographic will take your designs to a new level. Love the look of rhinestones but don’t want to go through all the hassle? Holographic can be cut to look exactly like rhinestones, without having to go through all the extra work associated with applying rhinestone designs. The Holographic line also features a translucent color: Rainbow Pearl. Rainbow Pearl is unlike any other material, giving your designs an opalescent finish that changes depending on the color of the garment. Holographic can be cut with laser systems.
Holographic is 110 Microns / 4.3 Mils and is a Polyester composition.
$10.00
-
Description
Adheres To:
- 100% Cotton
- Poly / Cotton Blends
- 100% Polyester
- Leather
Composition: Polyester
Blade: 45° or 60°
Thickness: 110 Microns/4.3 Mils
Layerable: Must Be Top Most Layer
Actual Width: 19.66″
Backing: Pressure Sensitive
Finish: Gloss
Technical Specifications
| Application instructions (home iron) • Set iron dial between Cotton and Linen • Cover with Heat Transfer Cover Sheet or Multipurpose Paper • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 10-15 seconds • If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds • Peel carrier cold |
Application Instructions (heat press) • Cover with Heat Transfer Cover Sheet or Multipurpose Paper • Preheat garment for 2-3 seconds • Apply design at 320°F/160°C • Use medium pressure for 15-20 seconds • Peel carrier cold |
 |
Cricut: Blade: Standard Setting: Light Cardstock |
 |
Silhouette Cameo: Blade: Standard, 3 Material: Heat Transfer, Smooth Speed: 8 Force: 14 |
 |
Brother ScanNCut: Blade: Standard, 2 Cut Speed: 1 Cut Pressure: 3 |
 |
Roland GX/GS-24: Blade: 45° Gram Force: 180-190 Offset: .250 Speed: 30 cm/s |
 |
Graphtec: Blade: 45° Force: 17-18 Tool: CB09U+0 Speed: 30 cm/s |
 |
MH, SC2, LP3, and Titan1: Blade: 45°/60° Gram Force: 85-90 Speed: 300 mm/s *Blade Advancing Varies |
 |
Titan 2 & 3: Blade: 45°/60° Gram Force: 75-80 Speed: 300 mm/s *Blade Advancing Varies |
Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.
Laundering:
- Wait 24 hours before first wash
- Machine wash warm or cold / mild detergent
- Dry on normal dryer setting
- Do not dry clean
