Siser EasyWeed Extra 15” White Heat Transfer Vinyl

Siser

EasyWeed® Extra shares almost all the great benefits of EasyWeed, with the added bonus of adhering to nylon! EasyWeed Extra is on a pressure-sensitive carrier sheet so you can cut detailed designs and weed them effortlessly. The ability to peel your designs HOT or COLD offers you the option to peel each item as it comes off the press, or to stack all the applied garments and peel after the job is complete. Looking to provide multi-color designs for your customers? EasyWeed Extra – with its semi-gloss finish, can be layered, extending your creativity and allowing you to say “yes” to more complicated designs.

EasyWeed Extra is 90 Microns / 3.5 Mils and is a PU composition.

$42.99$344.99

Description

Applies to:

  • 100% uncoated polyester
  • poly/cotton blends
  • Lightly siliconed nylon
  • Leather

Specifications:

  • PU composition
  • Pressure sensitive backing
  • Semi-gloss finish
  • 85 Microns / 3.5 Mils
  • 45°/60° blade
  • Can be layered

 

Technical Specifications

Application instructions (home iron)

• Set iron dial between Cotton and Linen
• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Place on flat, hard surface (ironing board not recommended)
• Press iron with medium/firm pressure (do not slide iron)
• Press each section of design for 10-15 seconds
• If areas of design lift after application, replace cover sheet
and re-press for 5-10 seconds
• Peel carrier hot or cold
Application Instructions (heat press)

• Cover with Heat Transfer Cover Sheet or Multipurpose Paper
• Preheat garment for 2-3 seconds
• Apply design at 305°F/150°C
• Use medium pressure for 10-15 seconds
• Peel carrier hot or cold
Cricut:   Blade: Standard   Setting: Iron-on

Silhouette Cameo:   Blade: Standard, 2   Material: Heat Transfer, Smooth   Speed:   Force: 4

Brother ScanNCut:   Blade: Standard, 2   Cut Speed: 1   Cut Pressure: 1

Roland GX/GS-24:   Blade: 45°   Gram Force: 80-90   Offset: .250   Speed: 25-50 cm/s

Graphtec:  Blade: 45°  Force: 8-9  Tool: CB09U+0  Speed: 30 cm/s

MH, SC2, LP3, and Titan1:  Blade: 45°/60°  Gram Force: 80-85  Speed: 300 mm/s  *Blade Advancing Varies

Titan 2 & 3   Blade: 45°/60°   Gram Force: 80-85   Speed: 300 mm/s  *Blade Advancing Varies


Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs.

Laundering:

  • Wait 24 hours before 1st wash
  • Machine wash warm or cold / mild detergent
  • Dry on normal dryer setting
  • Do not dry clean

Technical Sheets / Safety Data Sheets / Documents

Video

Product categories

Reviews

Reviews

Only logged in customers who have purchased this product may leave a review.

You May Also Like

Additional Options

×